Car Alarms: python alarm troubleshooting, python alarm system, vehicle alarms

Question
I would like some advice on whats wrong with my python alarm system, I am not sure if it is the remote or something else. The remote will send the command to lock/arm or unlock/disarm my suburban but usually beeps and shows signal was sent but not received, sometimes it takes a very long time to respond and even when I am standing next to the vehicle, any suggestions? On the back of the remote it has rpn 479v/p/c on it

Answer
Sorry about this, but legally prescribed.
Due to a mutual agreement with Directed
Electronics, I don't provide information
here for service or, support on any DEI
vehicle alarms or, remote start systems
since they have a dealer network designed
for that. That's how they want it.

Your's is one such device of DEI's.

However, for questions about DEI equipment
& support, I've set up an area where
you can get some help.

Please go to my forum at www.INSTALLSUPPORT.com
& ask Robert, the forum moderator, who is
there to assist you.

Just restate this inquiry there.
He's very good about getting back
to folks quickly.

That's

INSTALLSUPPORT.COM

Good luck.

ALARMTEK