QuestionQUESTION: May sound like a simple problem but I'm stumped. My washer motor has no power, neither does the low fluid switch on the resevoir. The light works as I know when I tap the ignition it comes on, but there apears to be no power there. I check fuses and they seem ok. I read a schematic and I see it picks up B+ but I don't know where to check for it. Says some "itergrated curcuit something"
ANSWER: what kinda car is this?
---------- FOLLOW-UP ----------
QUESTION: I guess it would help if you knew what I had, huh?
2006 Dodge ram 3500 Diesel 5.9l ctd
ANSWER: 06 are u not under warranty any more?
The pump gets power from the IPM and front controller the fuse box under the hood.
---------- FOLLOW-UP ----------
QUESTION: No warantee, wish I was I have put over $10,000 worth of repairs into this truck. That's another story though. I have 150,000 miles. where is the IPM and front controllers, how would I access them and check voltage or even jump a voltage for washer use. I reside in Arizona, I do come through Atlanta and will keep you in mind. I had to have my A/c pump replaced last September and the closest dealer available at the time was Okachobee, Fl so I made the drive down there with wind in my hair.
Answerhehe HIGHWAY MAN huh wow 150 in 2 year not to bad.
There is no fuse for the motor it straight wired from the Fuse box to the motor. The Front controller attached to the IPM tells the motor to run. I have seen either or both fail b4. Lift the hood and the fuse box is the IPM and Silver part is front controller.
Let me know if u do pass by and need something I can get parts at 10% over cost.
