Dodge Repair: 2000 Dodge Ram 1500 4X2 5.2 liter, dodge ram 1500, sensor signal

Question
This vehicle dies when in reverse(mostly),nuetral,drive unless you hold the gas down.It only comes up with code P1391 as a "pending".I did do a sync cam reset(it was off a little...8degrees),But that did nothing...WHAT IS GOING ON??? Is this a common thing?...where do i go?..do i just throw cam sensors and crank sensors at it? HELP! Thanks!

Answer
CKP SENSOR IMPROPERLY INSTALLED
CKP SENSOR CONNECTOR TERMINAL(S)
CKP SENSOR SIGNAL CKT WIRING HARNESS
CMP SENSOR CONNECTOR TERMINAL(S)
CMP SENSOR SIGNAL CKT WIRING HARNESS
DISTRIBUTOR POSITION NOT IN RANGE
CKP SENSOR
CRANKSHAFT NOTCHES DAMAGED OR MISALIGNED
PCM CONNECTOR TERMINAL(S) (CKP SENSOR)
PCM CONNECTOR TERMINAL(S) (CMP SENSOR

try and cam and crank first