Ford Repair: Interior question..., haynes manual, mustang lx

Question
Steve:
I recently purchased a 1993 Mustang LX in so-so condition, and I'm trying to clean it up a bit.  The middle console (the plastic one the runs between the front bucket seats) is pretty filthy, and I'm wanting to take it out and clean it good.  Unfortunately, I can't find any screws...and it's plastic, so I rather suspect it's just got little "snap" tabs.  I don't want to be too rough, though...because I don't want to break one off.  Also, it looks like there are three main pieces to it, and I don't know if I should try and take it apart from back to front or vice-versa.
Is there anything you can tell me on how to go about taking this middle console apart?  I don't guess I'd be lucky enough that there's a website anywhere showing an exploded diagram?
Any suggestions, advice greatly appreciated.
Warm regards,
David Gardner
[email protected]

Answer
David-

  Those consoles are such a pain.  You have to get to the carpet at the bottom and pull it back.  Every time I've had to remove a center console from a Fox bodied Mustang ('79-'93 models), I've had to pull at least one of the front seats to get it done.  As far as diagrams, I don't know of any sites that have them, but a Chiltons or Haynes manual probably would.  Hope this helps.

Steve