Jeep Repair: BLOWER MOTOR RELAY 2006 WRANGLER 4 CYL, negative battery cable, airbag deployment

Question
HI, I WAS ENQUIRING IF YOU CAN TELL ME WHERE THE BLOWER MOTOR RELAY IS LOCATED AND HOW TO REPLACE IT THANKS

Answer
24 - Heating and Air Conditioning/Controls/RELAY, Blower Motor/Removal
REMOVAL
Labor Operations: Click to display a list of Labor Operations associated with this procedure


WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.


1. Disconnect and isolate the negative battery cable.
2. Remove the glove box from the instrument panel (Refer to 23 - Body/Instrument Panel/GLOVE BOX, Instrument Panel - Removal) .

3. Locate the blower motor relay through the instrument panel glove box opening. The relay is mounted upright and to the right of the instrument panel harness Figure 1.
4. Remove the blower motor relay from its wire harness connector