QuestionQUESTION: when i scan my car ,it always say water temperature high at the entry ,but i don't know what means...i replace a new fan relay ,new thermostat sensor, new thermostat, new water pump .
ANSWER: what is the code number and what kinda jeep is this?
---------- FOLLOW-UP ----------
QUESTION: my car is a 99 grand cherokee laredo 4x4 4.0 v6 in line. the problem really is engine coolant temperature circuit high input ,like i told you i changed alls, new radiator,fan relay,thermostat,sensor,and water pump...thanks
ANSWER: there has to be a code I want to know the code number so I can give u the possible causes of that certain code.
---------- FOLLOW-UP ----------
QUESTION: THE CODE IS PO118. THANKS.
AnswerP0118-ECT SENSOR VOLTAGE TOO HIGH
When Monitored and Set Condition:
P0118-ECT SENSOR VOLTAGE TOO HIGH
When Monitored: With the ignition on and battery voltage greater than 10.4 volts.
Set Condition: The engine coolant temperature (ECT) sensor circuit voltage at the PCM
goes above 4.98 volts for more than 3 seconds.
POSSIBLE CAUSES
SENSOR GROUND CIRCUIT OPEN
ECT SENSOR SIGNAL CIRCUIT OPEN
ECT SENSOR SIGNAL CIRCUIT SHORTED TO VOLTAGE
WIRING HARNESS INTERMITTENT DEFECT
ECT SENSOR DEFECTIVE
PCM DEFECTIVE
this is what I wanted to know why did u replace the water pump and fan relay,and radiator?
