Land Rover Repair: Replacing ignition barrel Discovery 300TDI, receiver coil, door switch

Question
Hi,

Re: 1995 Discovery 300 TDIs

Yesterday I changed the ignition barrel. Since doing this I have had no end of problems with the immobiliser. I don't think I disconnected it when I changed the ignition switch assembly.

Since then I have had the alarm go off once or twice.

The new key is on the key ring with the electronic key fob. Which I found it needs in order to start.

I have unsuccessfully tried to reset the immobiliser with the door switch method.

Is there any way I can reset the immobiliser to recognise the new ignition switch?

Thanks

Brian


Answer
You don't have to program the new ignition barrel.
I think the problem will be the receiver coil at the barrel whic gets the signal from the key (with that it can identifies the key).

I think that coil or that plug will be the mistake.
Check that's connentor.