Motorcycle Repair: 1966 honda c100, honda c100, center screw

Question
how do i remove the rotor so i can replace the points and condenser?

Answer
Hi,

you really need a flywheel puller that screws into the center of the flywheel.
They prevent any damage to the flywheel as they are
very tight sometimes.

There are many places that sell them for various prices.
Your local Honda dealer could pull it off for you if
you can't find one quickly.

It should be M27 x 1 which is 27 mm diameter.

http://ep.yimg.com/ca/I/yhst-92821211804676_2259_25188505

You might be able to find a cheaper one online somewhere.

Measure the threads inside your flywheel to see if it is 27 mm

The tool is left hand thread and screws into the flywheel.
The center screw in turned in tight and then usually
a rap with a hammer will jar the flywheel loose.
The flywheel is on a key so don't lose that.

Warning:
Any other method or puller will usually damage the lighting
and ignition coils inside the flywheel area and ruin them.
Be careful!

Good luck,
WS
--------------------