Nissan Repair: 7/14/2000 97 Altima, haynes manual, stranger things

Question
On the 14th of July I emailed about the stalling and stalling.  I relaced the ECM and performed the suggestd checks you suggested with no success.  One thing I did find was if I disconnected the TBS the engine would rev without the bogging or stalling.  It rev even better if I plugged in the TBS and rotated its  shaft to about 70 to 100 %.  Engine runs fine while holding the TPS. It seems the TBS is in the wrong position.  This happens with the new and old TPS I have.  What gives? Is there a Pin out chart avalible so I can trace back the the computer?

G O Baker  

Answer
Go,

Stranger things have happened.  I would check the pinout on the new one to make sure it is the same.  And, if it is not a factory unit I would get one.  Also, check to make sure it is set properly.  Get a Haynes manual and follow the procedure.  Email me back if there are further problems and if you are in Las Vegas let me know and I will look at it personally.