Small Engines (Lawn Mowers, etc.): Snapper rear bearing replacement, stevensville md, snapper

Question
Eric,
    I have a Snapper RER mower (Model 281223BVE).  There is grease all over the inside of the left rear wheel and I suspect the bearing is bad.  I can't figure out how to replace it.  Would you know how this is done?
Thanks,
John Taylor
Stevensville, MD

Answer
Did you check out the Owner's or Part manual online?

http://www.snapper.com/support/

You need to remove the wheel and fender/side to replace the seal.  Since you mentioned there is grease on the inside of the wheel I am assuming you have the wheel off.  Correct?

Eric