Small Engines (Lawn Mowers, etc.): Engine Speed, briggs and stratton, hp briggs

Question
I Placed a carb from a blown 10 hp Briggs engine onto a 11 hp Briggs that was used but ran good when parked.  Change carnb because the carb on my used engine would not get any fuel through it.  Here is the problem.  When I changed carbs I also had to change the throttle linkage and the governor arm.  I am not sure about the spring on the governor, however, I am almost sure I hooked it just like it was on the other engine.  Anyway, when I crank the engine it wants to run wide open, too may RPM's.  I tried adjusting the governor as some post suggested and the engine either ran wide open of the throttle linkage had no effect at all.

I have the spring on the governor connected in such a way that when I move the throttle control to speed up the engine the governor is puled to the wide open position.  When I push the throttle control back the governor is released.  However, when I actually crank the engine it will run wide open no matter what I do with the throttle control.  I am sure you know exactly what is going on although I probably haven't done a very good job of explaining.  Engine Model is 28v707  Type 31116E1  Briggs and Stratton. Please help  

Answer

carb break down BILLY
I have enclosed a image of the set up for that carb on that engine that you said is the one you are using now from the model # you gave me. It may or may not be the same as the one you replaced it with I would need tat model # as well. Try this out to see if it will work.

I have inclosed the parts list break down.


11 692253
Tube-Breather    

11A 691328
Tube-Breather     

50 691711
Manifold-Intake     1   

51A 272554S
Gasket-Intake     1 10

53 690227
Stud (Carburetor)   1 10

54 690953
Screw (Intake Manifold)   1   

67 692297
Seal-Air Cleaner Nut     1 10

176 691917
Seal-O Ring (Air Cleaner Base)   1 10

185 690958
Nut (Air Cleaner Base)   1   

188 691693
Screw (Control Bracket)   1   

202 691841
Link-Mechanical Governor     1   

209 690480
Spring-Governor (Red)   1   

216 691840
Link-Choke     1   

222 694042
list Bracket-Control     1   

227 691374
Lever-Governor Control     1 10

232 691842
Spring-Governor Link     1 10

265 691024
Clamp-Casing     1   

267 690804
Screw (Casing Clamp)   1   

268 691025
Casing-Control Wire (Cut To Required Length)   1   

269 691026
Wire-Control (Cut To Required Length)   1 10

270 691027
Nut (Control Wire Casing)   1   

271 691028
Lever-Control     1 5

344 693675
Screw (Cable Clamp)   1   

404 691691
Washer (Governor Crank)   1   

445 496894S
Filter-Air Cleaner Cartridge     1   

467 691668
Knob-Air Cleaner     1   

505 691251
Nut (Governor Control Lever)   1 10

562 691119
Bolt (Governor Control Lever)   1 10

607 690703
Screw (Air Cleaner Brace)   1 10

607A 691693
Screw (Air Cleaner Brace)   1   

614 691620
Pin-Cotter     1   

616 692012
Crank-Governor     1 10

646 690460
Brace-Air Cleaner     1   

654 690958
Nut (Carburetor)   1   

875 696129
Base-Air Cleaner (Plastic)   1   

967 272403S
Filter-Pre Cleaner     1 10

968 691916
Cover-Air Cleaner     1   

971 691108
Screw (Air Cleaner Base to Carburetor)   1