Questionstill no spark. What should the Ohms be on the ignition coil? Our readings seem to be a little off.
-------------------------------------------
The text above is a follow-up to ...
-----Question-----
I can not get a spark. replaced points, condenser, plug
-----Answer-----
this is on one of those 2 cycle snow blowers i believe...
by any means.... the key shut off, or kill switch is shorting out..... check this. if you did everything right? , then it is grounding out. disconnect the kill wire and check. if its the key type? play with the key, back and forth, and check.
Answernot too sure on this....... but my book for a model close to yours??? is saying 400 ohms. if you have gone over everything else, > and still no fire???? then i,d say your coil did go out. no matter what the ohms are if all is checked... it is shot. needs replacing. i,m showing a figure of around $29
