GM-GMC: tail lights, couple dozen, trouble spot
Question1992 sonoma keeps blowing the fuse for the tail lights, i checked all the bulbs and thats not it, is there a trouble spot in the wiring causing a short
AnswerIt sounds like you have a dead short in that circuit. You will need to try and isolate where the fault is, it can be very difficult and sometimes frustrating, but with some patience and a couple dozen fuses you can figure it out I am sure. Disconnect as many connectors as you can for the rear lights, remove the bulbs etc etc etc. Then reinstall a good fuse. If it blows you will need to continue to disconnect things until you can install a fuse and it doesn't blow. This can also be done using an old headlight with terminals and wire to plug into where the fuse was, but if you are a beginner, using fuses is much safer, slightly more expensive, but much safer. You are basically trying to isolate where the short may be located. I cannot think off the top of my head any known trouble spots for that concern. If it is equipped with trailer wiring, it would be a good place to start.
Hope this helps