There are all kinds of reasons why you might need to remove the interior door panel on a Dodge Durango. If you need to replace a window motor, audio speaker, door control module, window track, or side-view mirror, you must remove the interior door panel.
Open the door to the Dodge Durango and roll the window all the way down. Remove the keys from the ignition afterward.
Remove the screw in the front upper corner of the door panel using a Phillips head screwdriver.
Locate and remove the interior door handle screw using a Phillips head screwdriver.
Locate and remove the Phillips head screw below and behind the armrest.
Remove the two Phillips head screws at the bottom of the door panel.
Lift the door panel upward and outward slightly. Secure the door panel with your leg and one hand.
Disconnect the mirror control knob wire. Use the small flathead screwdriver to press in on the clip lock, then unplug the wire from the harness.
Use the flathead screwdriver to swivel the plastic clip in a clockwise motion that retains the door linkage to the interior door handle assembly. Remove the metal rod of the interior door handle assembly out of the designated hole.
Locate the window control panel wire. Pull the red key lock outward to release the wire harness from the window control panel. Remove the door panel and set it aside.
Peel the dust sheet away from the door to gain access into the door cavity if desired. To replace the door panel, reverse the procedure.
